|Type:||Mini HVLP Gravity Feed|
|Nozzle size:||0.8-1.0 mm|
|Air Consumption:||1.6-4.0 cfm|
|Inlet Air Pressure:||50-70 PSI|
|Maximum Pattern Width:||100 mm|
|Material Capacity:||100 ml / 4 floz|
|Air inlet:||1/4" BSP|
Ideal for touch up and detailed work.
Die cast aluminum gun body with 2 step trigger control
Spray width and fluid adjustable.
HVLP gun which has greater transfer efficiency than suction feed
spray guns and reduces over spray, saving on time and material
The pot has a measuring scale on the side in both ml and fluid
ounces which enables you to see what is in the pot easier.
Suitable for all types of paint including water based paints.
Suitable to be used on all compressors with a tank - required HP 2
Comes complete with brass nozzle and bushing and has a stainless
steel needle for long lasting and reduced erosion.
HVLP mini spray gun
Plastic non drip cup
Gravity feed which means all of the paint is used up unlike suction
Measuring scale on the side of the cup
Nozzle size 0.8mm (so a lot smaller than others allowing work to be
done a lot more accurate)
Stainless steel needle (prevent erosion) and (allows water based
paint to be used)
Brass bushing and nozzle
Operating pressure 50-70 PSI
Air consumption 4 CFM
Maximum pattern width 100ml
Inlet air pressure 50 - 70 PSI
Paint pot capacity 100 ml / 4 fl oz (fluid ounce)
Air inlet 1/4 BSP (standard size for the majority of air tools)
ST-MINI2008 MiNi HVLP Spray Gun HVLP Gravity Feed 0.8mm Nozzle
125ml Plastic Cup :
How to spray:
Surface preparation is as important with a spray gun as with any
other kind of paint applicators. For car bodies, the paint is
rubbed down with Wet or Dry abrasive paper, used wet. For small
areas, the edges must blend in with the existing paintwork. Where
paintwork is rubbed down to bare metal, primer must be used.
Once the areas that you don’t want to paint have been masked off,
you can start spraying. A spray gun should be kept as horizontal as
possible and the nozzle at right-angles to the surface being
sprayed. For surfaces other than vertical or near-vertical ones,
you can get a flexible extension nozzle or an angle nozzle to allow
the gun to be used horizontally.
Spraying is carried out in a series of bands, each of which is done
in one ‘pass’ of the gun. It is important to keep the gun al the
same distance throughout the pass and that it is moving and
spraying as it reaches and leaves the area to be sprayed. This
takes a bit of practice which can be done on an old piece of board
before starting in earnest.